Features TD102 available from York Equipment Inc, Nebraska

MODULAR CUTTERBAR

The Case IH TD102 pull-type disc mower features a modular cutterbar design for superior crop flow that reduces streaking and ensures quick mowing.

• Cutterbar designed with:
• Shock protection to minimize repair expense
  • Discs protected from internal gear damage by drive hub
• Crop deflector shields located behind each end of cutterbar to direct cut crop into a wide swath inside the tire path
• Two end discs that co-rotate to provide a narrower swath
  • Capability to adjust swath from 60 in. - 95 in. (1.5 m - 2.4 m)
• Left cutterbar shield is hinged for easy service access

 

PTO DRIVELINE

• Overload protection is standard
• Primary PTO uses 80 degree Constant Velocity joint at tractor end to permit tight turns, reduce noise and extend service life
• Standard tractor tire bumpers protect PTO driveline and tractor tires

 

HEADER TILT ADJUSTMENT

• Tilt adjustable from 2 - 10 degrees using mechanical turnbuckle

TRANSPORT

Attaching and detaching mower from tractor easily accomplished with simple clevis hitch. The TD102 can be pulled by lighter weight tractors as weight is pulled vs. being carried on a 3-point hitch.

• Transport width is just 10 ft. 10 in. (3,300 mm) when end shields are folded
• Removable parking jack stand stored on top of tongue assembly
• Hydraulic tongue swing cylinder powers unit from transport to operating position
• 12-in. (305-mm) minimum cutterbar ground clearance in transport position
• Hinged right side cutterbar shield folds up for narrow transport
• Safety tow chain standard
• Low transport height eliminates need for implement lights